Electrical (pg 7)

This photo shows the wiring under the pilot side seat pan. This is prior to final cleaning up/tying of the wires so final assembly looks a little neater than this. The terminal strip takes the power from the nav lights switch at the panel and feed the wires going to the nav lights in each wingtip:

Here's a photo of the same area after cleaning up the wire installation a little bit. The spring seen here is part of the simple aileron trim system in the Van's design:

Wider angle view of the same area:

Wiring run across the passenger side out to the wing tip for nav and taxi light power:

Another angle of the pilot side seat pan wiring runs (the two white wires coming down through seat pan are for the pilot side push to talk switch):

Another angle of the passenger side wiring runs to the right wingtip:

Panel: pg 1 | pg 2 | pg 3 | pg 4 | pg 5 | pg 6

Electrical: pg 1 | pg 2 | pg 3 | pg 4 | pg 5 | pg 6 | pg 7 | pg 8

Back

This page was last updated on 12/18/11.

Click here for questions or feedback.